Kia Sedona: Compressor oil Repair procedures
Third generation YP (2014-2025) / Kia Sedona YP Service Manual / Heating,Ventilation And Air Conditioning / Air conditioning System / Compressor oil Repair procedures
| Oil Specification |
| 1. |
The HFC-134a system requires synthetic (PAG) compressor oil
whereas the R-12 system requires mineral compressor oil. The two oils
must never be mixed. |
| 2. |
Compressor (PAG) oil varies according to compressor model. Be sure to use oil specified for the model of compressor.
|
Handling of Oil
| 1. |
The oil should be free from moisture, dust, metal powder, etc. |
| 2. |
Do not mix with other oil. |
| 3. |
The water content in the oil increases when exposed to air.
After use, seal oil from air immediately. (HFC-134a Compressor Oil
absorbs moisture very easily.) |
| 4. |
The compressor oil must be stored in steel containers, not in plastic containers.
|
Compressor Oil Check
The oil used to lubricate the compressor circulates with the refrigerant.
Whenever replacing any component of the system or a large
amount of gas leakage occurs, add oil to maintain the original amount of
oil.
Oil total volume in system
PAG (FD46XG) 210 ± 10cc (7.4 ± 0.35oz.) |
Oil Return Operation
There is close affinity between the oil and refrigerant.
During normal operation, part of the oil recirculates with
the refrigerant in the system. When checking the amount of oil in the
system, or replacing any component of the system, the compressor must
run in advance for oil return operation. The procedure is as follows:
| 1. |
Open all the doors and engine hood. |
| 2. |
Start the engine and air conditioning switch to "ON" and set the blower motor control knob at its highest position. |
| 3. |
Run the compressor for more than 20 minutes between 800 and 1,000 rpm in order to operate the system. |
| 4. |
Stop the engine. |
Components and Components Location
Component Location Index
Engine Room
1. Ambient temperature Sensor2. Receiver-drier3. Condenser4. Compressor5. Discharge Hose6. Service Port (Low Pressure)7. Service Port (High Pressure)8. A/C P ...
Refrigerant Line Repair procedures
Replacement
1.
Discharge refrigerant from the refrigeration system.
2.
Replace faulty tube or hose.
Cap the open fittings immediately to keep moisture or dirt out ...
Other Information:
Exhaust System Repair procedures
Inspection
1.
Visually check the pipes, hangers and connections for severe corrosion, leaks or damage.
2.
Check for unusual exhaust sounds or abnormal exhaust fumes. ...
Front Lower Arm Repair procedures
Removal
1.
Remove the front wheel and tire (A) from the front hub.
Tightening torque:
88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)
Be careful not to d ...
Categories
- Home
- First Generation
- Second Generation
- Third generation
- Kia Sedona YP 2014-2025 Owners Manual
- Kia Sedona YP 2014-2025 Service Manual
Copyright © www.kisedona.com 2016-2025