Kia Sedona: Blind Spot Detection Radar Calibration Description and Operation
Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Body Electrical System / Blind Spot Detection System / Blind Spot Detection Radar Calibration Description and Operation
| Description |
To correctly sense vehicles on the neighboring lanes using
the radar, the direction of the sensor and the direction of the vehicle
must be aligned.
This is the BSD unit alignment. If this alignment is not
performed as in illustration below, it may cause degradation of
detection performance and false alarms.
In particular, rear bumper accident vehicles and vehicles that replaced BSD unit must carry out this alignment procedure.
| 1. |
Rear bumper accident vehicles and vehicles that replaced BSD units must perform BSD unit alignment using GDS. |
| 2. |
Select "BSD Radar Calibration" procedure in BSD system.
|
| 3. |
Perform the "BSD Radar Calibration" procedure according to the GDS screen message.
|
Blind Spot Detection Unit Repair procedures
Removal
Blind spot detection (BSD) unit
1.
Disconnect the negative (-) battery terminal.
Be careful when removing the blind spot detection unit. The bracket may brea ...
Other Information:
Multimedia Jack Repair procedures
Removal
Multimedia Jack
1.
Disconnect the negative (-) battery terminal.
2.
Remove the console upper cover (A).
(Refer to Body - "Floor Console Assembly")
3.
Disconnect the multimedia ja ...
Cowl Side Trim Components and Components Location
Component Location
1. Cowl side trim
...
Categories
- Home
- First Generation
- Second Generation
- Third generation
- Kia Sedona YP 2014-2026 Owners Manual
- Kia Sedona YP 2014-2026 Service Manual
Copyright © www.kisedona.com 2016-2026