Kia Sedona: Tail Gate Latch Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Body (Interior and Exterior) / Tail Gate / Tail Gate Latch Repair procedures

Replacement

Put on gloves to protect your hands.

•	When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.

•	Take care not to scratch the body surface.

1.	Remove the tail gate trim. (Refer to Tail Gate - "Tail Gate Trim")

2.	Disconnect the tail gate latch connector (A).

3.	Disconnect the tail gate motor connector (B) after loosening the nuts.

4.	Loosen the torx driver and remove the tail gate latch assembly (A).

Install in the reverse order of removal.

•	Make sure that the tail gate locks/unlocks and opens/closes properly.

•	Adjust the tail gate alignment.

•	Make sure that the connectors are connected properly.

Tail Gate Latch Components and Components Location

Component Location 1. Tail gate latch assembly ...

Tail Gate Back Panel Components and Components Location

Component Location 1. Tail gate back panel ...

Other Information:

Accelerator Position Sensor (APS) Schematic Diagrams
Circuit Diagram ...

Lane Departure Warning System (LDWS) Unit Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the LDWS unit cover (A). 3. Disconnect the LDWS unit connector (A). 4. Remove the LDWS unit after disengaging the mou ...

Kia Sedona: Tail Gate Latch Repair procedures

Tail Gate Latch Components and Components Location

Tail Gate Back Panel Components and Components Location

Other Information:

Categories