Kia Sedona: Power Window Switch Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Body Electrical System / Power Windows / Power Window Switch Repair procedures

Removal

•	Put on gloves to protect your hands.

•	When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.

•	Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.

•	Take care not to bend or scratch the trim and panels.

Driver / Passenger Power Window Switch

1.	Disconnect the negative (-) battery terminal.

2.	Remove the front door trim. (Refer to Body - "Front Door Trim")

3.	Loosen the front door armrest (A) mounting screws.

4.	Using a screwdriver or remover, separate the mounting clips and then remove the driver door module panel (A).

Loosen the mounting screws and then remove the driver door module(DDM) (A) after separating the mounting clips.

Be careful not to damage the mounting clips.

Rear Power Window Swtich

1.	Disconnect the negative (-) battery terminal.

2.	Remove the rear door trim. (Refer to Body - "Rear Door Trim")

3.	Remove the rear power window switch (A) after loosening the screws.

Installation

Driver / Passenger Power Window Switch

1.	Install the driver door module (DDM).

2.	Install the driver door module panel.

3.	Install the front door armrest mounting screws.

4.	Install the front door trim.

5.	Connect the negative (-) battery terminal.

Rear Power Window Swtich

1.	Install the rear power window switch.

2.	Install the rear door trim.

3.	Connect the negative (-) battery terminal.

Inspection

Diagnosis With GDS

The body electrical system can be quickly diagnosed for faulty parts using vehicle diagnostic system (GDS).

The diagnostic system (GDS) provides the following information:

(1)	Self diagnosis : Checking the failure code (DTC) and display

(2)	Current data : Checking the system input/output data state

(3)	Actuation test : Checking the system operation condition

(4)	Additional function : Other controlling such as he system option and zero point

2.	Select the ''Car model'' and the system to be checked in order to check the vehicle with the tester.

3.	Select the ''Body Control Module (BCM)'' to check the driver seat or assistant door module (DDM/ADM).

4.	Select the "Current Data" menu to search the current state of the input/output data. The input/output data for the sensors corresponding to the driver seat or assistant door module (DDM/ADM) can be checked.

5.	If you wish to check the power door lock operation by force, select "Actuation test".

Power Window Switch Schematic Diagrams

Circuit Diagram Driver Power Window Switch Assist Power Window Switch [Assist Power Window Module (ADM, IMS)] [Assist Power Window Switch (Non-IMS)] Rear Power Window Switch ...

Power Window Relay Repair procedures

Inspection Diagnosis With GDS 1. It can quickly diagnose defects of power window by communicating with GDS. GDS can operate actuator forcefully, monitor input/output values and self diagnose. ...

Other Information:

SRS Control Module (SRSCM) Description and Operation
Description The primary purpose of the SRSCM (Supplemental Restraints System Control Module) is to determine an event that warrants restraint system air bag deployment. The SRSCM must decide w ...

Press brake pedal to start engine (for smart key system)
This warning message illuminates if the Engine Start/Stop Button changes to the ACC position twice by pressing the button repeatedly without depressing the brake pedal. It means that you ...

Kia Sedona: Power Window Switch Repair procedures

Power Window Switch Schematic Diagrams

Power Window Relay Repair procedures

Other Information:

Categories