Kia Sedona: Power Steering Oil Pump Repair procedures - Hydraulic Power Steering System - Steering System - Kia Sedona YP Service ManualKia Sedona: Power Steering Oil Pump Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Steering System / Hydraulic Power Steering System / Power Steering Oil Pump Repair procedures

Removal
1.
Drain the power steering fluid.
2.
Remove the drive belt.
(Refer to Engine Mechanical System - "Drive Belt")
3.
Remove the pressure hose (B) from the oil pump and the suction hose from the suction pipe (C).

Tightening torque:
53.9 ~ 63.7 N.m (5.5 ~ 6.5 kgf.m, 39.8 ~ 47.0 lb-ft)

4.
Loosen the mounting bolts (A) and then remove the power steering pump.

Tightening torque:
16.7 ~ 25.5 N.m (1.7 ~ 2.6 kgf.m, 12.3 ~ 18.8 lb-ft)

5.
Install in the reverse order of removal.
Installation
1.
Install in the reverse order of removal.
2.
Add power steering fluid to reservoir.
3.
Bleed the power steering system.
(Refer to General Information - "Repair procedures(Air bleeding)")
Power Steering Hoses Repair procedures
Removal 1. Drain the power steering fluid. 2. Remove the surge tank. (Refer to Engine Mechanical System - "Surge Tank") 3. Remove the center muffler (Refer to Engine Mechanical System - ...

Steering wheel
...

Other Information:

Rear climate control
To turn on the rear climate control system; From the front seat 1. Set the rear climate control selection (REAR ON) button in the front climate control panel to the ON position. 2. Set the rear f ...

Oil Pressure Switch Components and Components Location
Components 1. Oil cover2. Oil cover gasket3. Oil pressure switch ...

Categories

Copyright © www.kisedona.com 2016-2026