Kia Sedona: Front Door Belt Inside Weatherstrip Repair procedures - Front Door - Body (Interior and Exterior) - Kia Sedona YP Service ManualKia Sedona: Front Door Belt Inside Weatherstrip Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Body (Interior and Exterior) / Front Door / Front Door Belt Inside Weatherstrip Repair procedures

Replacement
1.
Remove the front door trim.
(Refer to Front Door - "Front Door Trim")
2.
Remove the front door belt inside weatherstrip (A).

3.
Install in the reverse order of removal.
   
Replace any damaged clips.
Front Door Belt Outside Weatherstrip Repair procedures
Replacement 1. Pull down front door window glass by pressing the power window glass switch. 2. After loosening the mounting screws, remove the front door belt outside weatherstrip (A). 3. ...

Front Door Side Weatherstrip Repair procedures
Replacement 1. Loosen the front door checker (B) mounting bolt. Tightening torque : 19.6 ~ 29.4 N.m (2.0 ~ 3.0 kgf.m,14.5 ~ 21.7 lb-ft) 2. Detach the clips, and then remove the front doo ...

Other Information:

Repair procedures
On-vehicle Inspection Inspect ignition coil assembly and Perform spark test 1. Check for DTCs.     • If a DTC is present, perform troubleshooting in accordanc ...

Adjusting the height up and down
To raise the headrest, pull it up to the desired position (1). To lower the headrest, push and hold the release button (2) on the headrest support and lower the headrest to the desired position ...

Categories

Copyright © www.kisedona.com 2016-2026