Kia Sedona: Injector Drive Box (IDB) Repair procedures - Engine Control System - Engine Control / Fuel System - Kia Sedona YP Service ManualKia Sedona: Injector Drive Box (IDB) Repair procedures

Third generation YP (2014-2025) / Kia Sedona YP Service Manual / Engine Control / Fuel System / Engine Control System / Injector Drive Box (IDB) Repair procedures

Removal
1.
Turn the ignition switch off and disconnect the battery negative (-) Terminal.
2.
Remove the mounting nuts (A) and disconnect the connector (B), and then remove the injector drive box.

Installation
1.
Install in the reverse order of removal.

IDB mounting nut:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Injector Drive Box (IDB) Schematic Diagrams
IDB terminal and In/Output IDB terminal function Connector [E09] Pin No.DescriptionConnected to1- 2- 3- 4- 5- 6- 7- 8- 9- 10- 11- 12- 13- 14- 15- 16Injector (Cyl ...

ETC (Electronic Throttle Control) System Specifications
Specification [Throttle Position Sensor (TPS)] Throttle angle(°)Output Voltage (V) [Ref=5V]TPS1TPS200.54.5100.964.05201.413.59301.873.14402.322.68502.782.23603.231.77703.691.32804.140.86904.60. ...

Other Information:

Rear Washer Switch Repair procedures
Inspection 1. Check for continuity between the terminals while operating the wiper and washer switch. If it is not in normal condition, replace wiper and wiper switch. Rear Wiper Switch Rear ...

Components and Components Location
Component Location 1. Hood switch2. Burglar horn3. BCM & RF receiver4. Key warning switch5. Front door lock actuator & switch6. Rear door lock actuator & switch7. Tail gate actuator & ...

Categories


Copyright © www.kisedona.com 2016-2025