Kia Sedona: Hood Latch Components and Components Location - Hood - Body (Interior and Exterior) - Kia Sedona YP Service ManualKia Sedona: Hood Latch Components and Components Location

Third generation YP (2014-2025) / Kia Sedona YP Service Manual / Body (Interior and Exterior) / Hood / Hood Latch Components and Components Location

Component Location

1. Hood lower latch assembly

Hood Latch Release Handle Repair procedures
Replacement 1. Using a screwdriver or remover, remove the hood release handle (A).     • Use a 6mm hex bit to press the center until the handle easily pulls off ...

Hood Latch Repair procedures
Replacement 1. Loosen the fastener and remove the front bumper upper cover (A). 2. Remove the hood lower latch assembly (A) mounting bolts. Tightening torque : 7.8 ~ 11.8N.m (0.8 ~ 1.2kgf. ...

Other Information:

For power sliding door
1. Put the shift lever in the P (Park). 2. Close the fuel filler lid. 3. Change the position of fuse switch to OFF on the driver's side fuse panel and change the position of fuse switch to ON ...

Press start button again (for smart key system)
This warning message illuminates if you can not operate the Engine Start/Stop Button when there is a problem with the Engine Start/Stop Button system. It means that you could start the engin ...

Categories


Copyright В© www.kisedona.com 2016-2025