Kia Sedona: System operation
Ventilation
1. Set the mode to the 
position.
2. Set the air intake control to the outside (fresh) air position.
3. Set the temperature control to the desired position.
4. Set the fan speed control to the desired speed.
Heating
1. Set the mode to the 
position.
2. Set the air intake control to the outside (fresh) air position.
3. Set the temperature control to the desired position.
4. Set the fan speed control to the desired speed.
5. If dehumidified heating is desired, turn the air conditioning system (if equipped) on.
Rear vents
The vent can be adjusted by rotating the blade.
✽ NOTICE
If all the vents are closed, it may cause some noise. Always open 2 vents
or more. ...
Air conditioning
All Kia Air Conditioning Systems are filled with R-134a refrigerant.
1. Start the engine. Press the air conditioning button.
2. Set the mode to the position.
3. Set the air intake control to the o ...
Other Information:
Auto Defogging Sensor (DATC only) Repair procedures
Inspection
To inspect and diagnose the sensor, refer to Self-Diagnosis procedure and DTC guide.
Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the auto defogging se ...
Smart key Diagnostic Repair procedures
Inspection
Self Diagnosis With Scan Tool
Using the GDS, it can quickly diagnose defects of SMART KEY
system. GDS can operate actuator forcefully, monitor input/output values
and perform self d ...
Categories
- Home
- First Generation
- Second Generation
- Third generation
- Kia Sedona YP 2014-2026 Owners Manual
- Kia Sedona YP 2014-2026 Service Manual
