Kia Sedona: Shift Lever Components and Components Location - Automatic Transaxle Control System - Automatic Transaxle System - Kia Sedona YP Service ManualKia Sedona: Shift Lever Components and Components Location

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Shift Lever Components and Components Location

Components

1. Shift lever
2. Shift lever bracket
3. Main shaft
4. Manual mode switch housing
5. Shift lock solenoid




6. Key interlock switch
7. Main connector
8. Shift cable assembly
9. Shift cable retainer




Inhibitor Switch Repair procedures
Inspection Power Circuit Inspection 1. Disconnect the Inhibitor switch connector. 2. Ignition KEY "ON"" & Engine "OFF".. 3. Measure voltage between supplied power and ground at inhi ...

Shift Lever Repair procedures
Removal 1. Move the shift lever to "N" range. 2. Disconnect the battery negative (-) cable. 3. Remove the knob (A) and boots (B) by pulling them in the direction of the arrow after separ ...

Other Information:

Vehicle weight glossary
This section will guide you in the proper loading of your vehicle and/or trailer, to keep your loaded vehicle weight within its design rating capability, with or without a trailer. Properly loadin ...

Components and Components Location
Components 1. Front pillar trim2. Cowl side trim3. Center pillar upper trim4. Center pillar assist trim5. Center pillar lower trim6. Rear pillar trim7. Tailgate fillar trim8. Front door scuff tri ...

Categories

Copyright © www.kisedona.com 2016-2026