Kia Sedona: Fuel Tank Air Filter Repair procedures - Evaporative Emission Control System - Emission Control System - Kia Sedona YP Service ManualKia Sedona: Fuel Tank Air Filter Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Emission Control System / Evaporative Emission Control System / Fuel Tank Air Filter Repair procedures

Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) terminal.
2.
Lift the vehicle.
3.
Disconnect the canister close valve connector (A).
4.
Disconnect the ventilation hose (B) from the fuel tank air filter and canister close valve.
5.
Remove the canister close valve (C).

6.
Remove th fuel tank air filter (B) after loosening the mounting bolts (A).

Fuel tank air filter mounting bolt:
3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)

Installation
1.
Install in the reverse order of removal.
Fuel Filler Cap Description and Operation
Description A ratchet tightening device on the threaded fuel filler cap reduces the chances of incorrect installation, which would seal the fuel filler. After the gasket on the fuel filler cap ...

Exhaust Emission Control System
...

Other Information:

Components and Components Location
Components 1. Piston ring2. Piston3. Connecting rod4. Connecting rod upper bearing5. Piston pin6. Connecting rod lower bearing7. Connecting rod bearing cap8. Baffle plate9. Upper oil pan10. Cylin ...

Drive Belt Repair procedures
Removal and Installation 1. Remove the engine room under cover and engine room RH side cover. (Refer to Engine And Transaxle Assembly - "Engine Room Under Cover") 2. To release the tension, t ...

Categories

Copyright © www.kisedona.com 2016-2026