Kia Optima Manuals

Kia Sedona: Canister Repair procedures - Evaporative Emission Control System - Emission Control System - Kia Sedona YP Service ManualKia Sedona: Canister Repair procedures

Third generation YP (2014-2025) / Kia Sedona YP Service Manual / Emission Control System / Evaporative Emission Control System / Canister Repair procedures

Removal
1.
Turn the ignition switch OFF and disconnect the negative (-) battery terminal.
2.
Remove the fuel tank.
(Refer to Engine Control / Fuel System - "Fuel Tank")
3.
Disconnect the vapor tube quick-connector (A) and ventilation hose.

4.
Remove the canister mounting bolts, and then remove the canister (A) from the heater protect.
Canister mounting bolt:
3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)

Inspection
1.
Check for the following items visually.
–
Cracks or leakage of the canister
–
Loose connection, distortion, or damage of the vapor hose/tube

A: Canister ↔ Atmosphere
B: Canister ↔ Fuel Tank
C: Canister ↔ Intake Manifold
Installation
1.
Install in the reverse order of removal.
Repair procedures
Inspection [EVAP. Leakage Test] 1. Select "Evap. Leakage Test". 2. Proceed with the test according to the screen introductions. ...

Fuel Filler Cap Description and Operation
Description A ratchet tightening device on the threaded fuel filler cap reduces the chances of incorrect installation, which would seal the fuel filler. After the gasket on the fuel filler cap ...

Other Information:

On curves
On curves, the SCC may not detect a moving vehicle in your lane, and then your vehicle could accelerate to the set speed. Also, the vehicle speed will rapidly slow down when the vehicle ahead ...

Components and Components Location
Components 1. Front pillar trim2. Cowl side trim3. Center pillar upper trim4. Center pillar assist trim5. Center pillar lower trim6. Rear pillar trim7. Tailgate fillar trim8. Front door scuff tri ...

Categories

Copyright © www.kisedona.com 2016-2025