Kia Optima Manuals

Kia Sedona: Air Cleaner Repair procedures - Intake And Exhaust System - Engine Mechanical System - Kia Sedona YP Service ManualKia Sedona: Air Cleaner Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Engine Mechanical System / Intake And Exhaust System / Air Cleaner Repair procedures

Removal and Installation
Air Cleaner Assembly
1.
Remove the engine cover.
(Refer to Engine And Transaxle Assembly - "Engine Cover")
2.
Remove the air duct (A).

3.
Remove the battery.
(Refer to Engine Electrical System - "Battery")
4.
Remove the air cleaner assembly.
(1)
Disconnect the barometric pressure sensor (BPS) connector (A).
(2)
Disconnect the breather hose (B).
(3)
Disconnect the brake vacuum hose (C).
(4)
Remove the air cleaner assembly (D).
Tightening torque
Hose clamp bolt : 2.9 ~ 4.9 N.m (0.3 ~ 0.5 kgf.m, 2.2 ~ 3.6 lb-ft)
Air cleaner assembly bolts : 7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.8 ~ 7.2 lb-ft)

5.
Install in the reverse order of removal.
Air Cleaner Element
1.
Open the air cleaner element cover (A) by lifting up the air cleaner element cover handle (B).

2.
Unlock the air cleaner element camshaft (A) by turning in the direction of arrow.

3.
Replace the air cleaner element (A) with a new one.

   
Grab the handle (B) to pull out the air cleaner element.
4.
Lock the air cleaner element camshaft and then close the air cleaner element cover.
Inspection
1.
Remove the air cleaner element.
2.
Check if the air filter is excessively dirty. If so, replace the air cleaner element.
3.
If the air cleaner element needs to be cleaned, blow compressed air as shown in the illustration to clean it.

   
Be fully aware of the direction of using compressed air on the air cleaner.
4.
Reinstall the air cleaner element.
Air Cleaner Components and Components Location
Components 1. Air intake shield2. Air duct3. Air cleaner assembly4. Resonator5. Air intake hose6. Breather hose ...

Surge Tank Components and Components Location
Components 1. Surge tank stay2. Surge tank ...

Other Information:

Transmitter precautions
The transmitter will not work if any of following occur : - The ignition key is in the ignition switch. - You exceed the operating distance limit (about 10 m [30 feet]). - The battery in the t ...

Roof Side Moulding Repair procedures
Replacement [General Type]     Put on gloves to protect your hands.     • When prying with a flat-tip screwdriver, wrap it with pro ...

Categories

Copyright © www.kisedona.com 2016-2026