Kia Optima Manuals

Kia Sedona: Rear Power Mosfet Repair procedures - Rear Heater - Heating,Ventilation And Air Conditioning - Kia Sedona YP Service ManualKia Sedona: Rear Power Mosfet Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Heating,Ventilation And Air Conditioning / Rear Heater / Rear Power Mosfet Repair procedures

Inspection
1.
Turn the ignition switch ON.
2.
Manually operate the control switch and measure the voltage of the blower motor.
3.
Operate the control switch to raise the voltage up to high speed.

Segment
Manual Blower Voltage (V)
1
3.8
2
4.6
3
5.9
4
7.2
5
8.3
6
9.5
7
11.3
8
Battery (+)

Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the luggage side trim [RH].
(Refer to Body - "Luggage Side Trim")
3.
Disconnect the power mosfet connector and then remove the power mosfet (A) after loosening the screws.

4.
Install in the reverse order of removal.
Rear Mode Control Actuator Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the mode control actuator connector. 3. Verify that the mode control actuator operates to the defrost mode when 12V is connected t ...

Rear In-car Sensor Repair procedures
Replacement     Put on gloves to protect your hands.     • When prying with a flat-tip screwdriver, wrap it with protective tape, an ...

Other Information:

Front Wheel Speed Sensor Components and Components Location
Components 1. Front wheel speed sensor2. Front wheel speed sensor connector ...

Disc brakes wear indicator
When your brake pads are worn and new pads are required, you will hear a high-pitched warning sound from your front brakes or rear brakes. You may hear this sound come and go or it may occur whene ...

Categories

Copyright © www.kisedona.com 2016-2026