Kia Sedona: Field Effect Transistor (DATC) Repair procedures| Inspection |
| 1. |
Turn the ignition switch ON. |
| 2. |
Manually operate the control switch and measure the voltage of the blower motor. |
| 3. |
Operate the control switch to raise the voltage up to high speed.
Specification
|
| 4. |
If the measured voltage is not within specification,
substitute with a known-good field effect transistor and check for
proper operation. |
| 5. |
Replace the field effect transistor if it is proved that there is a problem with it. |
| Replacement |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the glove box housing.
(Refer to Body - "Glove Box Housing") |
| 3. |
Disconnect the connector (A) and then remove the field effect transistor (B) after loosening the mounting screws.
|
| 4. |
Install in the reverse order of removal. |
Blower Resistor (Manual) Repair procedures
Climate Control Air Filter Description and OperationGeneral Information
Towing
If the vehicle needs to be towed, call a professional towing
service. Never tow vehicle with just a rope or chain. It is very
dangerous.
[Front]
[Rear]
Emergency Towing
There are thr ...
Panic
The horn sounds and hazard warning lights flash for about 27 seconds if this
button is pressed for more than 0.5 second. To stop the horn and lights, press any
button on the transmitter. ...