Kia Sedona: Cluster Ionizer (DATC only) Repair procedures - Air conditioning System - Heating,Ventilation And Air Conditioning - Kia Sedona YP Service ManualKia Sedona: Cluster Ionizer (DATC only) Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Heating,Ventilation And Air Conditioning / Air conditioning System / Cluster Ionizer (DATC only) Repair procedures

Inspection
1.
Press the MODE switch more than 4 times within 2 seconds while pressing the OFF switch.
Display
Fail description
00
Normal
50
Cluster ion generator fault

* For diagnostic procedure, refer to DTC guide.
Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the glove box housing.
(Refer to Body - "Glove Box Housing")
3.
Disconnect the cluster ionizer connector (A).
4.
Remove the cluster ionizer (B) after loosening the screw.

5.
Install in the reverse order of removal.
Cluster Ionizer (DATC only) Description and Operation
Description The cluster ionizer disinfects and decomposes bad smell from the air conditioner or air inflow. Also, it cleans the inside air of a vehicle. When the ignition switch is ON, the ion ...

Heater
...

Other Information:

Sliding the sunroof
To open the sunroof, pull the sunroof control lever backward. To close the sunroof, push the sunroof control lever forward. To open the sunroof automatically : Pull the sunroof control lever back ...

To adjust the sensitivity of Smart Cruise Control
The sensitivity of vehicle speed when following the front vehicle to maintain the set distance can be adjusted. Go to the User Settings Mode (Driving Assist) and select SCC (Smart Cruise Control ...

Categories

Copyright © www.kisedona.com 2016-2026