Inspection |
Replacement |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the auto defogging sensor cover (A). |
3. |
Remove the auto defogging sensor (A) after disconnecting the auto defogging sensor connector (B). |
4. |
Install in the reverse order of removal. |
Transaxle Control Module (TCM) Repair procedures
Inspection
1.
TCM ground circuit test: Measure resistance between TCM and
chassis ground using the backside of TCM harness connector as TCM side check point.
Specification: Below 1Ω
...
Easy access function
The system will move the driver's seat automatically as follows :
Without smart key system
- It will move the driver ...