Kia Sedona: In-car Sensor (DATC only) Description and Operation
Third generation YP (2014-2024) / Kia Sedona YP Service Manual / Heating,Ventilation And Air Conditioning / Air conditioning System / In-car Sensor (DATC only) Description and Operation
| Description |
The In-car air temperature sensor is built in the heater & A/C control unit.
The sensor consists of a thermistor that measures the inside
temperature. The signal decided by the resistance value that changes in
accordance with perceived inside temperature, is delivered to heater
control unit, and according to this signal, the control unit regulates
in-car temperature to intended value.
[AVN Type]
[AUDIO Type]
Evaporator Temperature Sensor Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the evaporator temperature sensor connector.
3.
Measure resistance between terminals “+” and “-” of the evaporator tempera ...
Photo Sensor Description and Operation
Description
The photo sensor is located at the center of the defrost nozzles.
The photo sensor contains a photovoltaic (sensitive to
sunlight) diode. The solar radiation received by its light r ...
Other Information:
Disarmed stage
The system will be disarmed when
The doors (and tailgate) are unlocked with the transmitter (or smart key)
or the ignition key.
Pull the power sliding door out handle while the power door ON/ ...
Anti-Pinch Strip Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the tail gate trim.
(Refer to Body - "Tail Gate Trim")
3.
Disconnect the anti-pinch strip sensor connector (A).
4.
R ...
Categories
- Home
- First Generation
- Second Generation
- Third generation
- Kia Sedona YP 2014-2024 Owners Manual
- Kia Sedona YP 2014-2024 Service Manual
Copyright © www.kisedona.com 2016-2024