Removal |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the front seat back cover.
(Refer to Body - "Front Seat Back Cover") |
3. |
Disconnect the lumbar support motor connectors (A). |
4. |
Press the 2 mounting clips (A) from front seat back. |
5. |
Remove the lumber support assembly (A). |
Installation |
1. |
Install the lumbar support assembly. |
2. |
Connect the lumbar support motor connectors. |
3. |
Install the front seat back cover. |
4. |
Connect the negative (-) battery terminal. |
Inspection |
1. |
The body electrical system can be quickly diagnosed for faulty parts using vehicle diagnostic system (GDS).
The diagnostic system (GDS) provides the following information:
|
2. |
Select the ''Car model'' and the system to be checked in order to check the vehicle with the tester. |
3. |
Select the ''Power seat module (PSM)'' to check the power seat module (PSM). |
4. |
Select the ''Current Data" menu to search the current state of the input/output data.
The input/output data for the sensors corresponding to the power seat module (PSM) can be checked. |
5. |
If you wish to check the power door lock operation by force, select "Actuation test". |
1. |
Disconnect the connectors for each motor.
[Lumbar support motor] |
2. |
With the battery connected directly to the motor terminals, check if the motors run smoothly. |
3. |
Reverse the connections and check that the motor turns in reverse. |
4. |
If there is an abnormality, replace the motors. |
Specifications
Specification
Ignition System
Ignition Coil
ItemSpecificationRated Voltage (V)12Operating Voltage (V)5 ~ 16Primary Coil Resistance (Ω)0.62 ± 10% [20°C (68°F)]Secondary Coil Resistance ...
Components and Components Location
Component Location
1. Back view camera2. AVN head unit
...