Kia Optima Manuals

Kia Sedona: Rear Wiper Motor Repair procedures - Rear Wiper/Washer - Body Electrical System - Kia Sedona YP Service ManualKia Sedona: Rear Wiper Motor Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Body Electrical System / Rear Wiper/Washer / Rear Wiper Motor Repair procedures

Removal
   
Set up to automatically operate wipers of rear window glass when reverse gear shift is engaged while the wipers of windshield glass are in operation in ''Instrument Panel - User Setting Menu (USM).
1.
Detach the rear wiper cap (A).

2.
Remove the rear wiper arm & blade (A) after removing rear wiper HEX nut (B).

3.
Remove the rear wiper cap & pad (A).

4.
Remove the tailgate trim after opening the tailgate.
(Refer to Body - "Tailgate Trim")
5.
Disconnect the rear wiper motor connector (A) and then remove the rear wiper motor (B) after loosening bolts.

Installation
1.
Install the rear wiper motor assembly.
Tightening torque bolt :
6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)
2.
Install the tailgate trim.
3.
Install the rear wiper arm cap after tightening the nut.
Tightening torque Nut :
8.8 ~ 12.7 N.m (0.9 ~ 1.3 kgf.m, 6.5 ~ 9.4 lbf.ft)
4.
Set the rear wiper blade and to the lowest defogger heat line and tailgate glass.

Inspection
Rear Wiper Motor
1.
Remove the connector from the rear wiper motor.
2.
Connect battery positive (+) and negative (-) cables to terminals 2 and 1 respectively.
3.
Check that the motor operates normally. Replace the motor if it operates abnormally.
No.
Description
1
Battery (+)
2
Parking
3
Switch
4
Ground

Automatic Stop Operation Check
1.
Operate the motor at low speed using the stalk control.
2.
Stop the motor operation anywhere except at the off position by disconnecting terminal 2.
3.
Connect the positive (+) lead from the battery to terminal 2 and the negative (-) lead to terminal 1.
4.
Check that the motor stops running at the off position.

Components and Components Location
Component Location 1. Head cap2. Rear wiper arm nut3. Rear wiper arm & blade4. Cap & pad assembly5. Rear wiper motor assembly6.Rear wiper motor bolt ...

Rear Washer Switch Repair procedures
Inspection 1. Check for continuity between the terminals while operating the wiper and washer switch. If it is not in normal condition, replace wiper and wiper switch. Rear Wiper Switch Rear ...

Other Information:

Power Sliding Door (PSD) Control Module Schematic Diagrams
Circuit Diagram ...

Components and Components Location
Components 1. HECU module2. Front wheel speed sensor3. Rear wheel speed sensor4. Yaw rate & Lateral G sensor5. Steering Angle Senser6. ABS Warning lamp7. Parking brake/EBD warning lamp8. ESC ...

Categories

Copyright © www.kisedona.com 2016-2026