Kia Optima Manuals

Kia Sedona: Auto Head lamp leveling Unit Repair procedures - Head lamp leveling Device - Body Electrical System - Kia Sedona YP Service ManualKia Sedona: Auto Head lamp leveling Unit Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Body Electrical System / Head lamp leveling Device / Auto Head lamp leveling Unit Repair procedures

Inspection
1.
Ignition "ON".
2.
Turn on the head lamp switch.
3.
Check for operation. If the aim of the head lamps changes smoothly when the head lamp leveling switch is turned.
4.
If the operation does not work well, inspect the connector and terminals to be sure they are all making good contact.
If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
If the terminals look OK, go to step 5.
5.
Substitute with a known-good head lamp assembly and check for proper operation.
Removal
1.
Remove the head lamp leveling unit connector (A).
2.
Remove the head lamp leveling unit (B) after loosening the mounting bolts.
Tightening torque :
3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)

Installation
1.
Install the head lamp leveling unit.
2.
Connect the head lamp leveling unit connector.
Auto Head lamp leveling Unit Description and Operation
Description According to driving environment and loading state of vehicle, head lamp lighting direction is changed to keep the driver''s visibility range and to protect the driver''s vision fro ...

Auto Head lamp leveling Unit Troubleshooting
Inspection with GDS Initialization and diagnosis sequence by using GDS equipment. The content below summarizes the procedure for A/S using GDS. No.Procedure1Locate vehicle to flat plane2Tire ch ...

Other Information:

Fuel Gauge
This gauge indicates the approximate amount of fuel remaining in the fuel tank. ✽ NOTICE The fuel tank capacity is given in chapter 8. The fuel gauge is supplemented by a low fuel warn ...

Blower Resistor (Manual) Repair procedures
Inspection 1. Measure the resistance between the terminals. 2. If the measured resistance is not within specification, the blower resistor must be replaced (after removing the resistor). Repl ...

Categories

Copyright © www.kisedona.com 2016-2026