Kia Sedona: Parking Assist Sensor Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Body Electrical System / Front / Rear Parking Assist System / Parking Assist Sensor Repair procedures

Removal

Front/Rear PAS Sensor

1.	Disconnect the negative (-) battery terminal.

2.	Remove the front/rear bumper cover. (Refer to Body - "Front Bumper Cover") (Refer to Body - "Rear Bumper Cover")

3.	Disconnect the connector from the ultrasonic sensor. [Front, Rear Center] [Rear Side Left] [Rear Side Right]

4.	Pull out the ultrasonic sensor (A) after opening the sensor holder. [Front, Rear Center] [Rear Side Left] [Rear Side Right]

Installation

Front/Rear PAS Sensor

1.	Install the PAS sensor and connector.

2.	Install the front/rear bumper cover.

3.	Connect the negative (-) battery terminal.

Parking Assist Sensor Schematic Diagrams

Circuit Diagram ...

Fuses And Relays

...

Other Information:

Crash Pad Center Panel Repair procedures
Replacement Put on gloves to protect your hands. • When prying with a flat-tip screwdriver, wrap it with protective tape, an ...

Curtain Airbag (CAB) Module Description and Operation
Description Curtain airbags are installed inside the headliner (LH and RH) to protect the driver and passenger from danger when side crash occurs. The SRSCM determines deployment of curtain air ...

Kia Sedona: Parking Assist Sensor Repair procedures

Parking Assist Sensor Schematic Diagrams

Fuses And Relays

Other Information:

Categories