Kia Optima Manuals

Kia Sedona: Front Seat Cushion Cover Repair procedures - Front Seat - Body (Interior and Exterior) - Kia Sedona YP Service ManualKia Sedona: Front Seat Cushion Cover Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Body (Interior and Exterior) / Front Seat / Front Seat Cushion Cover Repair procedures

Replacement
   
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Put on gloves to protect your hands.
1.
Remove the front seat assembly.
(Refer to Front Seat - "Front Seat Assembly")
2.
Remove the front seat shield outer cover.
(Refer to Front Seat - "Front Seat Shield Outer Cover")
3.
Remove the front seat shield inner cover.
(Refer to Front Seat - "Front Seat Shield Inner Cover")
4.
Remove the front seat lower protector (A).

5.
Disconnect the front seat connectors (A).

6.
Disconnect the front seat cushion fixing hook (A) from front seat cushion frame.
[LH]

[RH]

[FRONT]

[REAR]

7.
Remove the front seat cushion cover (A) from the front seat cushion frame.

8.
After removing the velcro tape (A) and hog-ring clips (B) from inside the front seat cushion cover, separate the front seat cushion cover (C).

9.
Install in the reverse order of removal.
   
•
Make sure that the connectors are plugged in properly.
•
Replace any damaged clips.
•
To prevent wrinkles, make sure that the material is stretched evenly over the cover (B) before securing the hog-ring clips (A).
•
Replace the hog-ring clips with new ones using special tool [09880-4F000].

Front Seat Cushion Cover Components and Components Location
Component Location 1. Front seat cushion cover ...

Front Seat Frame Assembly Components and Components Location
Component Location 1. Front seat back frame assembly2. Front seat cushion frame assembly ...

Other Information:

Electric power steering
Power steering uses the motor to assist you in steering the vehicle. If the engine is off or if the power steering system becomes inoperative, the vehicle may still be steered, but it will require ...

Canister Close Valve (CCV) Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the CCV connector. 3. Measure resistance between the CCV terminal 1 and 2. 4. Check that the resistance is within the specific ...

Categories

Copyright © www.kisedona.com 2016-2026