Kia Optima Manuals

Kia Sedona: Front Seat Assembly Repair procedures - Front Seat - Body (Interior and Exterior) - Kia Sedona YP Service ManualKia Sedona: Front Seat Assembly Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Body (Interior and Exterior) / Front Seat / Front Seat Assembly Repair procedures

Replacement
1.
Open the front seat mounting bolt cap (A), then loosen the mounting bolts (B).
Tightening torque :
44.1 ~ 58.8N.m (4.5 ~ 6.0kgf.m, 32.5 ~ 43.4lb-ft)
[Front]

[Rear]

2.
Disconnect the airback connector (A), seat warmer & power seat connector (B) and front seat belt buckle connector (C).
[Driver''s]

[Passenger''s]

3.
Remove the front seat assembly (A).

4.
Install in the reverse order of removal.
   
Seat Mounting Bolt Installation Procedure
•
Set the seat in the rearmost position. Check that each slide is locked, and then temporarily tighten the front mounting bolts.
•
Set the seat in the foremost position. Check that each slide is locked, and then completely tighten the rear mounting bolts.
•
Set the seat in the rearmost position again and then completely tighten the front mounting bolts.
•
Check that the seat operates to and fro smoothly and that the locking portion locks properly.
Front Seat Assembly Components and Components Location
Component Location 1. Front seat assembly ...

Front Seat Shield Outer Cover Components and Components Location
Component Location 1. Front seat shield front cover2. Front seat shield outer cover ...

Other Information:

Cruise Control Switch Components and Components Location
Components 1. Remote control switch (LH) 2. Remote control switch (RH) ...

Operating conditions
The indicator on the switch will illuminate when the Blind Spot Detection System (BSD) switch is pressed with the Engine Start/Stop Button ON. If vehicle speed exceeds 30 km/h (18.6 mph), the sys ...

Categories

Copyright © www.kisedona.com 2016-2026