Kia Sedona: Rear Bumper Cover Repair procedures| Replacement |
|
Take care not to bend or scratch the trim and panels. |
| 1. |
Remove the rear combination lamp cover (A) using a screwdriver or remover.
|
| 2. |
After loosening the mounting screws, remove the rear combination lamp (A).
|
| 3. |
Push the lock pin, then disconnet the rear combination lamp connector (A).
|
| 4. |
Loosen the clips on rear bumper upper.
|
| 5. |
Remove the rear mud guard (A) after loosening the screws.
|
| 6. |
Remove the rear bumper side under cover (A) after loosening the mounting clips.
[LH]
[RH]
|
| 7. |
Disconnect the rear bumper side.
|
| 8. |
Push the lock pin, then disconnect the rear bumper main connector (A).
|
| 9. |
Remove the rear bumper cover (A).
|
| 10. |
Install in the reverse order of removal.
|
Rear Bumper Cover Components and Components Location
Rear Bumper beam Assembly Components and Components Location26 Brake Control Solenoid Valve(26/B_VFS) Specifications
Specification
Item SpecificationControl typeN/L (Normal Low)Control pressure kpa(kgf/cm², psi)"9.81 ~ 500.14(0.1 ~ 5.1, 1.42 ~ 72.54)"Current value (mA)50 ~ 850Coil resistance(Ω)5.1 ± 0.3
...
SRS Care
The SRS is virtually maintenancefree and so there are no parts you can safely
service by yourself. If the SRS air bag warning light does not illuminate, or continuously
remains on, have your vehic ...