Kia Optima Manuals

Kia Sedona: Schematic Diagrams - Surround View Monitoring (SVM) System - Body Electrical System - Kia Sedona YP Service ManualKia Sedona: Schematic Diagrams

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Body Electrical System / Surround View Monitoring (SVM) System / Schematic Diagrams

SVM System Input/Output
1.
Camera input
Item
Specification
Lens angle of view
190 degrees
Angle of view
Horizontal
186 degrees
Vertical
135 degrees
Function
Provides the original image of the wide angle image
(no additional function)
Application location
Same camera applied to the front, rear, left and right

2.
SVM image output
The SVM unit carries out distortion compensation and video merging on the image from 4 cameras installed around the vehicle, indicates steering interlocking guidelines and others, and outputs them in analog.
3.
SVM switch
When the switch is ON, this is used as a control input signal that operates the front view mode.
4.
Ignition input
The SVM unit outputs images only when IGN2 ON. When IGN2 OFF , it is an SVM OFF state, and limits image outputting.
SVM unit uses signals inputted through IGN pin or M_CAN communication to determine whether IGN2 is ON or OFF.
5.
Output switch indicator lamp
SVM units output power through PWM waves from the LED located in the SVM switch to show the user whether the switch has been pressed.
6.
Input chassis CAN (C_CAN)
The SVM unit uses C_CAN to receive information about the vehicle''s condition and to decide whether to carry out main SVM operations.
7.
Multimedia CAN input/output (M_CAN)
M-CAN signal is changed to C-CAN signal by IGPM (routing function or central gateway) and then SVM unit can use this C-CAN signal.
M_CAN is used to communicate with IGPM to send and receive the following information:
–
Send SVM mode conversion requests for SVM output images (e.g. Navi mode→SVM mode)
–
Send requests for user SVM view conversion
–
Send compensation coordinates for tolerance compensation
–
Send warning messages to be indicated in the AVN
–
Send any user option changes
Description and Operation
Description Surround View Monitoring System (SVM) is the system that allows video monitoring of 360 degrees around the vehicle. The system consists of 4 ultra optical cameras mounted around the ...

Repair procedures
Inspection Tolerance Compensation Tolerance compensation compensates for the error margins of surround view video that occur due to the installation tolerance when the four cameras comprising ...

Other Information:

Main Crash Pad Assembly Repair procedures
Replacement     Put on gloves to protect your hands.     • When prying with a flat-tip screwdriver, wrap it with protective tape, an ...

Warning type
The system will activate when: 1.The system is on. 2.Vehicle speed is above 30 km/h (18.6 mph ). 3.Other vehicles are detected in the rear side. WARNING The Blind Spot Detection System with L ...

Categories

Copyright © www.kisedona.com 2016-2026