Kia Sedona: Repair procedures - Back view camera System - Body Electrical System - Kia Sedona YP Service ManualKia Sedona: Repair procedures

Third generation YP (2014-2025) / Kia Sedona YP Service Manual / Body Electrical System / Back view camera System / Repair procedures

Removal
1.
Disconnect the negetive (-) battery terminal.
2.
Remove the tailgate back panel.
(Refer to Body - "Tailgate Back Panel")
3.
Remove the back view camera (A) after loosening the screws (2EA).

Installation
1.
Install the back view camera.
2.
Install the tailgate back panel.
Description and Operation
Description Back view camera will activate when the backup light is ON with the ignition switch ON and the shift lever in the R position. This supplemental system shows the back of the vehicle on ...

BCM (Body Control Module)
...

Other Information:

Blower Resistor (Manual) Repair procedures
Inspection 1. Measure the resistance between the terminals. 2. If the measured resistance is not within specification, the blower resistor must be replaced (after removing the resistor). Repl ...

Troubleshooting
Engine Overheat Troubleshooting Inspection RemedyVisual inspectionInspect for shortage of coolant in reservoir tank .Reinspect after replenishing coolant.Inspect for coolant pollution after remo ...

Categories


Copyright В© www.kisedona.com 2016-2025