Your spare tire is stored underneath your vehicle, directly below the right sliding door.
1. Open the right sliding door and find the plastic hex bolt cover on the floor.
2. Remove the cover.
3. Use the wheel lug nut wrench to loosen the bolt enough to lower the spare tire.
Turn the wrench counterclockwise until the spare tire reaches the ground.
4. After the spare tire reaches the ground, continue to turn the wrench counterclockwise, and draw the spare tire outside. Never rotate the wrench excessively, otherwise the spare tire carrier may be damaged.
5. Remove the retainer from the center of the spare tire.
6. Remove the cover from the spare tire.
Rail Pressure Sensor (RPS) Repair procedures
Inspection
1.
Connect the GDS to the Data Link Connector (DLC).
2.
Measure the output voltage of the RPS at idle and various engine speed.
Removal
1.
Turn the ignition switch OFF and d ...
Rear Hub - Carrier Components and Components Location
Components
1. Rear carrier assembly2. Parking brake assembly3. Rear hub assembly4. Rear brake disc
...