1.Remove the towing hook from the tool case.
2.Remove the hole cover pressing the lower part of the cover on the front bumper.
3.Install the towing hook by turning it clockwise into the hole until it is fully secured.
4.Remove the towing hook and install the cover after use.
Components and Components Location
Components
1) SVM unit basically uses C-CAN signal only to communicate about the vehicle''s condition.
•
Steering wheel angle sensor : C-CAN
•
Veh ...
If the engine does not start
If engine doesn't turn over or turns over slowly
1.If your vehicle has an automatic transaxle, be sure the shift lever is in N
(Neutral) or P (Park) and the emergency brake is set.
2.Check the ...