Kia Sedona: Operating conditions - BSD (Blind Spot Detection) / LCA (Lane Change Assist) - Blind spot detection system (BSD) - Driving your vehicle - Kia Sedona YP Owners ManualKia Sedona: Operating conditions

Third generation YP (2014-2024) / Kia Sedona YP Owners Manual / Driving your vehicle / Blind spot detection system (BSD) / BSD (Blind Spot Detection) / LCA (Lane Change Assist) / Operating conditions

The indicator on the switch will illuminate when the Blind Spot Detection System (BSD) switch is pressed with the Engine Start/Stop Button ON.

If vehicle speed exceeds 30 km/h (18.6 mph), the system will activate.

If you press the switch again, the switch indicator and system will be turned off.

If the ignition switch is turned OFF and ON the system returns to the previous state.

When the system is not used turn the system off by turning off the switch.

When the system is turned on the warning light will illuminate for 3 seconds on the outside rearview mirror.

BSD (Blind Spot Detection) / LCA (Lane Change Assist)
...

Warning type
The system will activate when: 1.The system is on. 2.Vehicle speed is above 30 km/h (18.6 mph ). 3.Other vehicles are detected in the rear side. WARNING The Blind Spot Detection System with L ...

Other Information:

Pantoscopic Camera Repair procedures
Removal Front Pantoscopic Camera 1. Disconnect the negative (-) battery terminal. 2. Remove the front bumper cover. (Refer to Body - "Front Bumper Cover") 3. Remove the pantoscopic camer ...

Transaxle Oil Temperature Sensor Description and Operation
Description • The sensor used is a thermistor (NTC) in which resistance changes with temperature variation. • The TCM supplies about 5 voltage to the sensor; the output value ...

Categories


Copyright © www.kisedona.com 2016-2024