Kia Sedona: Mode Control Actuator Description and Operation - Heater - Heating,Ventilation And Air Conditioning - Kia Sedona YP Service ManualKia Sedona: Mode Control Actuator Description and Operation

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Heating,Ventilation And Air Conditioning / Heater / Mode Control Actuator Description and Operation

Description
Located in the heater unit, the mode control actuator adjusts the position of the mode door by operating the mode control actuator according to the signal from the A/C control unit.
Pressing the mode select switch shifts the mode control actuator in the order of Vent → Bi-Level → Floor → Mix.
Temperature Control Actuator Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the temperature control actuator connector. 3. Verify that the temperature control actuator operates to the cool position when 1 ...

Mode Control Actuator Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the mode control actuator connector. 3. Verify that the mode control actuator operates to the defrost mode when 12V is connected t ...

Other Information:

Troubleshooting
Troubleshooting Problem Symptoms Table Use the table below to help you find the cause of the problem. The numbers indicate the priority of the likely cause of the problem. Check each part i ...

Windshield wipers
Operates as follows when the ignition switch is turned ON. MIST : For a single wiping cycle, move the lever to this (MIST/) position and release it. The wipers will operate continuously if the leve ...

Categories

Copyright © www.kisedona.com 2016-2026