Kia Sedona: Front Bumper Cover Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Body (Interior and Exterior) / Front Bumper / Front Bumper Cover Repair procedures

Replacement

•	When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.

•	Put on gloves to protect your hands.

Take care not to bend or scratch the trim and panels.

1.	Remove the front bumper upper cover (A) after loosening the screws.

2.	Loosen the radiator upper cover mounting bolts.

3.	Remove the engine room under cover (A) after loosening the mounting screws and bolts.

Loosen the front bumper side''s mounting screws to separate the side part.

When you pull out the front bumper, the side part of the front bumper could be damaged by the projection.

5.	Disconnect the fog lamp connector (A) and front bumper main connector (B). [LH] [RH]

6.	Remove the front bumper cover (A).

Install in the reverse order of removal.

•	Make sure that the connectors are plugged in properly.

•	Replace any damaged clips.

Front Bumper Cover Components and Components Location

Component Location 1. Front bumper cover ...

Radiator Grill Components and Components Location

Component Location 1. Radiator grill ...

Other Information:

High Mounted stop lamp Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the rear spoiler. (Refer to Body - "Rear Spoiler") 3. Remove the high mounted stop lamp assembly (A) after loosening nut ...

Auto Defogging Sensor (DATC only) Description and Operation
Description The auto defogging sensor is installed on the front window glass. The sensor judges and sends signal to blow out wind for defogging if moisture occurs. On receiving the signal from ...

Kia Sedona: Front Bumper Cover Repair procedures

Front Bumper Cover Components and Components Location

Radiator Grill Components and Components Location

Other Information:

Categories