Kia Sedona: Detecting sensor - BSD (Blind Spot Detection) / LCA (Lane Change Assist) - Blind spot detection system (BSD) - Driving your vehicle - Kia Sedona YP Owners ManualKia Sedona: Detecting sensor

Third generation YP (2014-2026) / Kia Sedona YP Owners Manual / Driving your vehicle / Blind spot detection system (BSD) / BSD (Blind Spot Detection) / LCA (Lane Change Assist) / Detecting sensor

The sensors are located inside of the rear bumper.

Always keep the rear bumper clean for the system to work properly.

Warning type
The system will activate when: 1.The system is on. 2.Vehicle speed is above 30 km/h (18.6 mph ). 3.Other vehicles are detected in the rear side. WARNING The Blind Spot Detection System with L ...

Warning message
Type B Type C The message will appear to notify the driver there are foreign substances on the rear bumper or it is hot near the rear bumper. The light on the switch and the system will turn ...

Other Information:

Purge Control Solenoid Valve (PCSV) Schematic Diagrams
Circuit Diagram ...

Rear Evaporator Core Repair procedures
Replacement 1. Remove the rear heater & A/C unit. (Refer to Rear Heater - "Rear Heater Unit") 2. Remove the rear heater & A/C lower case after loosening the screws. 3. Remove the ...

Categories

Copyright © www.kisedona.com 2016-2026