Kia Sedona: Canister Repair procedures - Evaporative Emission Control System - Emission Control System - Kia Sedona YP Service ManualKia Sedona: Canister Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Emission Control System / Evaporative Emission Control System / Canister Repair procedures

Removal
1.
Turn the ignition switch OFF and disconnect the negative (-) battery terminal.
2.
Remove the fuel tank.
(Refer to Engine Control / Fuel System - "Fuel Tank")
3.
Disconnect the vapor tube quick-connector (A) and ventilation hose.

4.
Remove the canister mounting bolts, and then remove the canister (A) from the heater protect.

Canister mounting bolt:
3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)

Inspection
1.
Check for the following items visually.
Cracks or leakage of the canister
Loose connection, distortion, or damage of the vapor hose/tube

A: Canister ↔ Atmosphere
B: Canister ↔ Fuel Tank
C: Canister ↔ Intake Manifold
Installation
1.
Install in the reverse order of removal.
Repair procedures
Inspection [EVAP. Leakage Test] 1. Select "Evap. Leakage Test". 2. Proceed with the test according to the screen introductions. ...

Fuel Filler Cap Description and Operation
Description A ratchet tightening device on the threaded fuel filler cap reduces the chances of incorrect installation, which would seal the fuel filler. After the gasket on the fuel filler cap ...

Other Information:

Repair procedures
Teaching Procedures 1. Key Teaching Procedure Key teaching must be done after replacing a defective PCM (ECM) or when providing additional keys to the vehicle owner. The procedure starts with ...

Temperature control
The temperature will increase to the maximum (HI) by turning the knob to the extreme right. The temperature will decrease to the minimum (Lo) by turning the knob to the extreme left. When turn ...

Categories

Copyright © www.kisedona.com 2016-2026