Kia Sedona: Blind Spot Detection Unit Repair procedures
Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Body Electrical System / Blind Spot Detection System / Blind Spot Detection Unit Repair procedures
| Removal |
Blind spot detection (BSD) unit
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the rear bumper.
(Refer to Body - "Rear Bumper Cover") |
| 3. |
Disconnect the BSD connector (A) from the BSD unit.
|
| 4. |
Remove the BSD assembly (A) after loosening the mounting nuts.
|
| Installation |
Blind spot detection (BSD) unit
| 1. |
Place the RH and LH radar sensors on each side to get ready for installation. |
| 2. |
Install the radar sensor to the bracket correctly (distinguish RH & LH) with mounting nuts.
|
| 3. |
Connect the negative (-) battery terminal. |
Blind Spot Detection Unit Schematic Diagrams
Circuit Diagram
...
Blind Spot Detection Radar Calibration Description and Operation
Description
To correctly sense vehicles on the neighboring lanes using
the radar, the direction of the sensor and the direction of the vehicle
must be aligned.
This is the BSD unit alignment. ...
Other Information:
Specifications
Specification
ItemsBulb TypeBulb Wattage (W)FrontHead lamp (STD)LowH7SLL55HighH7LL55Head lamp (HID)LowD3S35HighH7LL55Turn signal lampPY28/8W28Position lampPY28/8W8Fog lampH8 or HB435 or 55Side re ...
Engine Mounting Repair procedures
Removal and Installation
Engine Mounting Bracket
1.
Disconnect the battery negative terminal.
2.
Install the jack to the edge of the lower oil pan (A) to support the engine.
&n ...
Categories
- Home
- First Generation
- Second Generation
- Third generation
- Kia Sedona YP 2014-2026 Owners Manual
- Kia Sedona YP 2014-2026 Service Manual
Copyright © www.kisedona.com 2016-2026