Removal |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the mirror (A) from the mirror holder.
|
3. |
Disconnect the heater connector (A) from mirror assembly. |
4. |
Remove the BSD warning lamp (A). |
Installation |
1. |
Install the BSD warning lamp and mirror. |
2. |
Connect the mirror heater connector. |
3. |
Connect the negative (-) battery terminal. |
Inspection |
1. |
Verify that the mirror operates properly as shown in the below table. BSD warning lamp |
Rear Spoiler Repair procedures
Replacement
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, an ...
Vehicle break-in process
No special break-in period is needed. By following a few simple precautions for
the first 600 miles (1,000 km) you may add to the performance, economy and life
of your vehicle.
Do not race the ...