Kia Sedona: Alternator Specifications - Charging System - Engine Electrical System - Kia Sedona YP Service ManualKia Sedona: Alternator Specifications

Third generation YP (2014-2020) / Kia Sedona YP Service Manual / Engine Electrical System / Charging System / Alternator Specifications

Specification
Item
Specification
Rated voltage
13.5V , 150A
Speed in use
1,500 ~ 18,000rpm
Voltage regulator
IC Regulator built in type
Default regulated voltage (V) [COM terminal]
14.0 ~ 15.5 (-35°C)
14.0 ~ 15.0 (25°C)
13.1 ~ 15.0 (140°C)
Regulator Setting Voltage (V) [COM terminal]
11.6 ~ 15.4
[5,000 rpm / min / 10A]

Repair procedures
Inspection Inspection Item • Battery efficiency inspection • Battery voltage inspection • Charging voltage insptection • General inspection • ...

Alternator Description and Operation
Description The Alternator has eight built-in diodes, each rectifying AC current to DC current. Therefore, DC current appears at alternator "B" terminal. In addition, the charging voltage of this ...

Other Information:

Canadian Programming Garage & gate openers
During programming, your hand-held transmitter may automatically stop transmitting. Continue to press and hold the HomeLink button (note steps 2 through 4 in the ...

Schematic Diagrams
Circuit Diagram Connector Pin Information No.Motor ConnectorSunroof Wiring Connector1Battery 1GND 12Open alarmRear lock switch3GND 1IGN4Rear lock switchSignal C5-Signal A6Signal CBattery 17Signa ...

Categories

Copyright © www.kisedona.com 2016-2020