Trouble Symptom Charts |
Trouble Symptom 1 |
Trouble symptom | Probable cause | Remedy |
The set vehicle speed varies greatly upward or downward "Surging" (repeated alternating acceleration and deceleration) occurs after setting | Malfunction of the vehicle speed sensor circuit | Repair the vehicle speed sensor system, or replace the part |
Malfunction of ECM | Check input and output signals at ECM |
Trouble symptom | Probable cause | Remedy |
The CC system is not canceled when the brake pedal is depressed | Damaged or disconnected wiring of the brake pedal switch | Repair the harness or replace the brake pedal switch |
Malfunction of the ECM signals | Check input and output signals at ECM |
Trouble symptom | Probable cause | Remedy |
The
CC system is not canceled when the shift lever is moved to the "N"
position (It is canceled, however, when the brake pedal is depressed) | Damaged or disconnected wiring of inhibitor switch input circuit | Repair the harness or repair or replace the inhibitor switch |
Improper adjustment of inhibitor switch | ||
Malfunction of the ECM signals | Check input and output signals at ECM |
Trouble symptom | Probable cause | Remedy |
Cannot decelerate (coast) by using the "SET/–" switch | Temporary damaged or disconnected wiring of "SET/–" switch input circuit | Repair the harness or replace the "SET/–" switch |
Malfunction of the ECM signals | Check input and output signals at ECM |
Trouble symptom | Probable cause | Remedy |
Cannot accelerate or resume speed by using the "RES/+" switch | Damaged or disconnected wiring, or short circuit, or "RES/+" switch input circuit | Repair the harness or replace the "RES/+" switch |
Malfunction of the ECM signals | Check input and output signals at ECM |
Trouble symptom | Probable cause | Remedy |
CC
system can be set while driving at a vehicle speed of less than 40km/h
(25mph), or there is no automatic cancellation at that speed | Malfunction of the vehicle-speed sensor circuit | Repair the vehicle speed sensor system, or replace the part |
Malfunction of the ECM signals | Check input and output signals at ECM |
Trouble symptom | Probable cause | Remedy |
The cruise main switch indicator lamp does not illuminate (although CC system is normal) | Damaged or disconnected bulb of cruise main switch indicator lamp | Repair the harness or replace the part. |
Harness damaged or disconnected |
Brake Booster Repair procedures
Brake Booster Operating Test
For simple checking of the brake booster operation, carry out the following tests.
1.
Run the engine for one to two minutes, and then stop it. If
the pedal depress ...
Special Service Tools
Special Service Tools
Tool Name / NumberIllustrationDescriptionRKE Battery Checker09954-2P100Measuring the RKE batteryvoltageCorrection jig for LDWS or LKAS09890-3V100Correction of LDWS (Lane Dep ...