Kia Sedona: Tail Gate Lift Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Body (Interior and Exterior) / Tail Gate / Tail Gate Lift Repair procedures

Replacement

Take care to not let the tailgate fall on you as the lifts are removed. Have a helper hold the tailgate open, or use a secure method to hold it open.

Remove the tail gate lifter (A) after loosening the bolts and socket clip and bolts (B).

Tightening torque:

6.9~10.8 N.m (0.7~1.1 kgf.m, 5.1~8.0 lb-ft)

•	Power tail gate type. (Refer to Body Eletrical System - "PTG Spindle")

•	Using a flat head screwdriver (A), remove the clip (B).

Install in the reverse order of removal.

Make sure that the tail gate locks and opens properly and locks securely.

Tail Gate Back Panel Repair procedures

Replacement Put on gloves to protect your hands. • When prying with a flat-tip screwdriver, wrap it with protective tape, an ...

Tail Gate Weatherstrip Repair procedures

Replacement 1. Remove the rear transverse trim. (Refer to Interior Trim - "Rear Transverse Trim") 2. Remove the tail gate weatherstrip (A). Do not apply sealant ...

Other Information:

Center console storage
To open the center console storage, pull up the lever. Center console sliding tray removal procedure ➀ Pull down the knob to slide the sliding tray. ➁ Check the lever located on t ...

Key not in vehicle (for smart key system)
This warning message illuminates if the smart key is not in the vehicle when you press the Engine Start/Stop Button. It means that you should always have the smart key with you. ...

Kia Sedona: Tail Gate Lift Repair procedures

Tail Gate Back Panel Repair procedures

Tail Gate Weatherstrip Repair procedures

Other Information:

Categories