Kia Sedona: Smart key Repair procedures

Third generation YP (2014-2025) / Kia Sedona YP Service Manual / Body Electrical System / Smart key System / Smart key Repair procedures

Smart Key

Smart Key Code Saving

1.	Connect the DLC cable of GDS to the data link connector (16 pins) in driver side crash pad lower panel, and then turn the power on GDS.

2.	Select the vehicle model and then perform "Smart key code saving".

3.	After selecting "Smart Key Code Saving" menu, push "Enter" key, then the screen will be shown as below.

4.	After saving the smart key code, press "OK" button.

5.	Enter the "Pin code" for the first key teaching.

6.	Press the SSB with smart key within 5 sec after pressing "OK".

7.	Confirm the message "First key teaching completed".

8.	Press the SSB with smart key within 5 sec after pressing "OK".

9.	Confirm the message "Second key teaching completed".

10.	Then the screen will be shown as below when smart key saving process is completed.

Smart key Diagnostic Repair procedures

Inspection Self Diagnosis With Scan Tool Using the GDS, it can quickly diagnose defects of SMART KEY system. GDS can operate actuator forcefully, monitor input/output values and perform self d ...

Smart key unit Components and Components Location

Components (1) Connector Pin Information No.Connector AConnector BConnector C1Immobilizer antenna GND outputB+IGN12Bumper antenna GND output--3Rear antenna GND output--4Interior antenna 2 GND ou ...

Other Information:

Intake Air Temperature Sensor (IATS) Schematic Diagrams
Circuit Diagram ...

To decrease the crusie control set speed
Follow either of these procedures: Move the lever down (to SET-), and hold it. Your vehicle set speed will decrease by 10 km/h (5 mph). Release the lever at the speed you want. Move the lev ...

Kia Sedona: Smart key Repair procedures

Smart key Diagnostic Repair procedures

Smart key unit Components and Components Location

Other Information:

Categories