Kia Sedona: Drive Plate Repair procedures - Cylinder Block - Engine Mechanical System - Kia Sedona YP Service ManualKia Sedona: Drive Plate Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Engine Mechanical System / Cylinder Block / Drive Plate Repair procedures

Removal and Installation
1.
Remove the automatic transaxle.
(Refer to Automatic Transaxle System - "Automatic Transaxle")
2.
Remove the adapter plate (A) and the drive plate (B).

Tightening torque :
71.6 ~ 75.5 N.m (7.3 ~ 7.7 kgf.m, 52.8 ~ 55.7 lb-ft)

3.
Install in the reverse order of removal.
Drive Plate Components and Components Location
Components 1. Drive plate2. Adapter plate ...

Rear Oil Seal Components and Components Location
Components 1. Rear oil seal2. Oil seal case ...

Other Information:

Transaxle Control Module (TCM) Schematic Diagrams
TCM Connector TCM terminal function Connector [A] PinDescription10CAN (High)27Ignition switch29Sports mode up switch35CAN (Low)44Inhibitor switch signal ''S1''45Inhibitor switch signal ''S2''4 ...

Windshield wipers
Operates as follows when the ignition switch is turned ON. MIST : For a single wiping cycle, move the lever to this (MIST/) position and release it. The wipers will operate continuously if the leve ...

Categories

Copyright © www.kisedona.com 2016-2026