Kia Sedona: Water Jacket Seperator Components and Components Location - Cylinder Block - Engine Mechanical System - Kia Sedona YP Service ManualKia Sedona: Water Jacket Seperator Components and Components Location

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Engine Mechanical System / Cylinder Block / Water Jacket Seperator Components and Components Location

Components

1. Water jacket separator

Components and Components Location
Components 1. Piston ring2. Piston3. Connecting rod4. Connecting rod upper bearing5. Piston pin6. Connecting rod lower bearing7. Connecting rod bearing cap8. Baffle plate9. Upper oil pan10. Cylin ...

Water Jacket Seperator Repair procedures
Removal 1. Remove the LH/RH cylinder head assembly and gasket. (Refer to Cylinder Head Assembly - "Cylinder Head") 2. Remove the water jacket seperators (A). Installation 1. Install the ...

Other Information:

Compressor Repair procedures
Removal 1. If the compressor is marginally operable, run the engine at idle speed, and let the air conditioning work for a few minutes, then shut the engine off. 2. Disconnect the negative ...

Fuel Tank Pressure Sensor (FTPS) Repair procedures
Inspection 1. Connect the GDS to the Data Link Connector (DLC). 2. Measure the output voltage of the FTPS. Pressure [kPa (kgf/cm², psi)]Output Voltage (V) [Ref=5V]-6.67 (-0.06, -0.97)0.502 ...

Categories

Copyright © www.kisedona.com 2016-2026