Kia Sedona: Front fog lamp bulbs
Type A
Type B
1. Remove the front bumper under cover.
2. Reach your hand into the back of the front bumper.
3. Disconnect the power connector from the socket.
4. Remove the bulb-socket from the housing by turning the socket counter clockwise until the tabs on the socket align with the slots on the housing.
5. Install the new bulb-socket into the housing by aligning the tabs on the socket with the slots in the housing. Push the socket into the housing and turn the socket clockwise.
6. Connect the power connector to the socket.
7. Reinstall the front bumper under cover.
✽ NOTICE
Always have the headlight aiming adjusted after an accident or the headlight assembly is reinstalled at a authorized Kia dealer.
Front side marker
1. Open the hood.
2. Remove the front cover(1) and headlamp assembly nuts(2).
3. Remove the headlamp assembly from the body of the vehicle
4. Remove the socket from the assembly by turning the so ...
Headlamp (HID type), Front position (LED), bulb replacement
If the light bulb does not operate, have the vehicle checked by an authorized
Kia dealer.
✽ NOTICE
HID lamps have superior performance vs. halogen bulbs. HID lamps are estimated
by the ma ...
Other Information:
Rear climate control
To turn on the rear climate control system;
From the front seat
1. Set the rear climate control selection (REAR ON) button in the front climate
control panel to the ON position.
2. Set the rear f ...
Anti-Pinch Strip Repair procedures
Inspection
1.
Use the GDS to check input/output values in the Power Sliding
Door control module for each position. If there''s any malfunctioning,
replace the anti-pinch strip.
2.
To chec ...
Categories
- Home
- First Generation
- Second Generation
- Third generation
- Kia Sedona YP 2014-2026 Owners Manual
- Kia Sedona YP 2014-2026 Service Manual
