Kia Sedona: Seat belt - Driver's 3-point system with emergency locking retractor - Seat belt restraint system - Seat belts - Safety features of your vehicle - Kia Sedona YP Owners ManualKia Sedona: Seat belt - Driver's 3-point system with emergency locking retractor

Third generation YP (2014-2024) / Kia Sedona YP Owners Manual / Safety features of your vehicle / Seat belts / Seat belt restraint system / Seat belt - Driver's 3-point system with emergency locking retractor

To fasten your seat belt :

To fasten your seat belt, pull it out of the retractor and insert the metal tab (1) into the buckle (2). There will be an audible "click" when the tab locks into the buckle.

The seat belt automatically adjusts to the proper length only after the lap belt portion is adjusted manually so that it fits snugly around your hips. If you lean forward in a slow, easy motion, the belt will extend and let you move around. If there is a sudden stop or impact, however, the belt will lock into position. It will also lock if you try to lean forward too quickly.

✽ NOTICE

If you are not able to pull out the seat belt from the retractor, firmly pull the belt out and release it. Then you will be able to pull the belt out smoothly.

Front seat

Height adjustment

You can adjust the height of the shoulder belt anchor to one of the 3 positions for maximum comfort and safety.

The height of the adjusting seat belt should not be too close to your neck. The shoulder portion should be adjusted so that it lies across your chest and midway over your shoulder near the door and not your neck.

To adjust the height of the seat belt anchor, lower or raise the height adjuster into an appropriate position.

To raise the height adjuster, pull it up (1). To lower it, push it down (3) while pressing the height adjuster button (2).

Release the button to lock the anchor into position. Try sliding the height adjuster to make sure that it has locked into position.

WARNING - Shoulder belt positioning

Never position the shoulder belt across your neck or face.

WARNING - Seat belt replacement

Replace your seat belts after being in an accident. Failure to replace seat belts after an accident could leave you with damaged seat belts that will not provide protection in the event of another collision.

Seat belt warning (for front passenger
Type A Type B The front passenger's seat belt warning light will activate to the following table when the ignition switch is in "ON" position. *1 The seat belt warning light w ...

Seat belts - Front passenger and rear seat 3-point system with combination locking retractor
To fasten your seat belt : Combination retractor type seat belts are installed in the rear seat positions to help accommodate the installation of child restraint systems. Although a combination r ...

Other Information:

Fuel Pressure Control Valve (FPCV) Repair procedures
Inspection 1. Turn the ignition switch OFF and disconnect the battery negative (-) terminal. 2. Disconnect the fuel pressure regulator valve connector. 3. Measure resistance between the fu ...

Components and Components Location
Component Location 1. Hood switch2. Burglar horn3. BCM & RF receiver4. Key warning switch5. Front door lock actuator & switch6. Rear door lock actuator & switch7. Tail gate actuator & ...

Categories


Copyright В© www.kisedona.com 2016-2024