Type A
Type B
The hazard warning flasher serves as a warning to other drivers to exercise extreme caution when approaching, overtaking, or passing your vehicle.
It should be used whenever emergency repairs are being made or when the vehicle is stopped near the edge of a roadway.
Depress the flasher switch with the ignition switch in any position. The flasher switch is located in the center facia panel. All turn signal lights will flash simultaneously.
Rear Oil Seal Repair procedures
Replacement
1.
Remove the transaxle assembly.
(Refer to Automatic Transaxle System - "Automatic Transaxle")
2.
Remove the drive plate.
(Refer to Cylinder Block - "Drive Plate")
3.
Remov ...
Repair procedures
Inspection
Special care is needed for the following points in case of working with the non-gloss timber trimming.
•
Wrap a protective tape around tools used ...