Kia Optima Manuals

Kia Sedona: Repair procedures - Delta Fixed Glass - Body (Interior and Exterior) - Kia Sedona YP Service ManualKia Sedona: Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Body (Interior and Exterior) / Delta Fixed Glass / Repair procedures

Removal
   
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Put on gloves to protect your hands.
   
•
Take care not to bend or scratch the trim and panels.
•
Do not scrape down to the painted surface of the body.
1.
Remove the front pillar trim.
(Refer to Interior Trim - "Front Pillar Trim")
2.
Loosen the nuts and remove the delta fixed glass (A).
Tightening torque :
3.9 ~ 4.4 N.m (0.4 ~ 0.45 kgf.m, 2.9 ~ 3.3 lb-ft)

3.
Cut out the delta fixed glass sealant using the utility knife.
   
Do not scrape down to the painted surface of the body.
   
•
Remove the rubber dam and fasteners from the body.
•
Mask off surrounding surfaces before painting.
Installation
1.
With a putt knife, scrape the old adhesive smooth to a thickness of about 2mm (0.08 in.) on the bonding surface around the entire delta fixed glass flange.
   
•
Do not scrape down to the painted surface of the body, as damaged paint may interfere with proper bonding.
•
Mask off surrounding surfaces before painting.
2.
Clean the body bonding surface with a sponge dampened in alcohol. After cleaning, keep oil, grease and water away from the surface.
3.
Apply a light coat of body primer to the outside of the body panel.
   
•
The primed surface should never be touched by hand. By doing so, the adhesive may not bond to the glass properly, causing a leakage after the windshield glass is installed.
•
Do not apply body primer to the glass.
•
Keep water, dust, and abrasive materials away from the primer.
4.
Peel off the tape from the delta fixed glass.
5.
Install the delta fixed glass (A) mounting nuts.
Tightening torque :
3.9 ~ 4.4 N.m (0.4 ~ 0.45 kgf.m, 2.9 ~ 3.3 lb-ft)

6.
Install the front pillar trim.
Components and Components Location
Component Location 1. Delta fixed glass ...

Quarter Fixed Glass
...

Other Information:

Inside lamp
Type A Type B 1. Open the tailgate. 2. Remove the service cover. 3. Remove the socket from the assembly by turning the socket counterclockwise until the tabs on the socket align with the s ...

Cruise Indicator Light
This indicator light illuminates : When the cruise control system is enabled. For more details, refer to ...

Categories

Copyright © www.kisedona.com 2016-2026