The auto defogging sensor is installed on the front window
glass. The sensor judges and sends signal to blow out wind for defogging
if moisture occurs. On receiving the signal from the sensor, the air
conditioner control module restrains moisture and eliminates fog by
controlling the intake actuator, A/C, auto defogging actuator, blower
motor rpm, and mode actuator.
Inspection
1.
Turn the ignition switch OFF.
2.
Remove the front bumper.
(Refer to Body - "Front Bumper Cover")
3.
Disconnect ambient temperature sensor.
4.
Check the resistance of the ...
Inspection
To inspect and diagnose the sensor, refer to Self-Diagnosis procedure and DTC guide.
Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the auto defogging se ...
Other Information:
Hood Weatherstrip Repair procedures
Replacement
1.
Remove the glue on both ends (A) of the hood weatherstrip (B).
•
Be careful not to scratch the hood weatherstrip.
2.
Install in the r ...
Rear mode selection
Front climate control is :
Rear air blows from the upper vents on the rear ceiling.
Front climate control is :
Rear air blows from the upper vents on the rear ceiling and the lower vents
...