Kia Sedona: Rear Washer Motor Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Body Electrical System / Rear Wiper/Washer / Rear Washer Motor Repair procedures

Inspection

With the washer motor connected to the reservoir tank, fill the reservoir tank with water.

Before filling the reservoir tank with water, check the filter for any foreign material or contamination. If necessary, clean the filter in the pump motor.

2.	Remove the front bumper cover. (Refer to Body - "Front Bumper Cover")

3.	Connect positive (+) and negative (-) battery cables to terminals 3 and 2 respectively to see that the washer motor runs and water is pumped.

Check that the motor operates normally.

Replace the motor if it operates abnormally.

No.	Description
1	Rear washer (+)
2	Ground

Rear Washer Switch Repair procedures

Inspection 1. Check for continuity between the terminals while operating the wiper and washer switch. If it is not in normal condition, replace wiper and wiper switch. Rear Wiper Switch Rear ...

Seat Electrical

...

Other Information:

Cluster Ionizer (DATC only) Description and Operation
Description The cluster ionizer disinfects and decomposes bad smell from the air conditioner or air inflow. Also, it cleans the inside air of a vehicle. When the ignition switch is ON, the ion ...

Valve Clearance Adjustment
Valve Clearance Inspection and Adjustment Inspect and adjust the valve clearance when the engine is cold (Engine coolant temperature : 20°C [68°F]) and cylinder hea ...

Kia Sedona: Rear Washer Motor Repair procedures

Rear Washer Switch Repair procedures

Seat Electrical

Other Information:

Categories