Kia Sedona: Description and Operation
Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Body Electrical System / Electro chromic Inside Rear View Mirror / Description and Operation
| Description |
The Electro Chromatic inside rear view Mirror (ECM) is
intended to dim the reflecting light in the rear view mirror. The
forward facing sensor detects the brightness of the surroundings while
the rearward looking sensor detects the intensity of the light from the
rear. The intensity of the light from the rear sensor is used by the
mirror to adjust the level of shading ranging from 7% to 85%. When the
reverse gear is engaged, it stops functioning.
| 1. |
The forward facing sensor sees if the brightness of the surroundings is low enough for the mirror to operate its function. |
| 2. |
The rearward looking sensor detects glaring of the reflecting light from a vehicle behind. |
| 3. |
The ECM is darkened to the level as determined by the
rearward looking sensor. When the glaring is no longer detected, the
mirror stops functioning.
|
| Automatic-dimming Function |
To protect your vision during nighttime driving, your mirror
will automatically dim upon detecting glare from the vehicles traveling
behind you. The auto-dimming function can be controlled by the Dimming
ON/OFF Button :
| 1. |
Pressing and holding the Feature Control button for more than
3 but less than 6 seconds turns the auto-dimming function OFF which is
indicated by the green Status Indicator LED turning off. |
| 2. |
Pressing and holding the Feature Control button again for
more than 3 but less than 6 seconds turns the auto-dimming function ON
which is indicated by the green Status Indicator LED turning on.
|
Components and Components Location
Components
...
Repair procedures
Removal
1.
Remove the ECM mirror connector (B) after removing the mirror wiring cover (A).
2.
Remove the mirror (A) pulling up in the direction of arrow.
Be caref ...
Other Information:
Manifold Absolute Pressure Sensor (MAPS) Repair procedures
Inspection
1.
Connect the GDS to the Data Link Connector (DLC).
2.
Measure the output voltage of the MAPS at idle and IG ON.
Pressure [kPa (kgf/cm², psi)]Output Voltage (V) [Ref=5V]20.0 (0 ...
Removable towing hook (front)
1.Remove the towing hook from the tool case.
2.Remove the hole cover pressing the lower part of the cover on the front bumper.
3.Install the towing hook by turning it clockwise into the hole until ...
Categories
- Home
- First Generation
- Second Generation
- Third generation
- Kia Sedona YP 2014-2026 Owners Manual
- Kia Sedona YP 2014-2026 Service Manual
Copyright © www.kisedona.com 2016-2026