Kia Optima Manuals

Kia Sedona: External AMP Repair procedures - AVN System - Body Electrical System - Kia Sedona YP Service ManualKia Sedona: External AMP Repair procedures

Third generation YP (2014-2025) / Kia Sedona YP Service Manual / Body Electrical System / AVN System / External AMP Repair procedures

Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the main crash pad assembly.
(Refer to Body - "Main Crash Pad Assembly")
3.
Remove the body control module.
(Refer to "BCM (Body Control Module)")
4.
Disconnect the external amplifier connector (A).

5.
Remove the external amplifier (A) after loosening the nuts.
   
Remove the external amp in the direction of the arrow.

Installation
1.
Install the external amplifier.
2.
Connect the external amplifier connector.
3.
Install the BCM (Body Conetrol Module).
4.
Install the main crash pad assembly.
5.
Connect the negative (-) battery terminal.
   
•
Make sure that the connectors are connected properly.
•
Check the AVN system.
External AMP Components and Components Location
Components Connector Pin Information No.Connector ANo.Connector B1Left front door (+)1Center front (+)2Right front door (+)2-3Left side door (+)3-4Right side door (+)4-5Subwoofer 2 (+)5Navi (+)6 ...

Speaker Repair procedures
Inspection 1. Troubleshooting for Speaker (1) Basic inspection of speaker Inspect the sound from speaker after verifying that the speaker mounting screws are removed and the wiring connector ...

Other Information:

Inhibitor Switch Repair procedures
Inspection Power Circuit Inspection 1. Disconnect the Inhibitor switch connector. 2. Ignition KEY "ON"" & Engine "OFF".. 3. Measure voltage between supplied power and ground at inhi ...

Instant Fuel Economy (3)
...

Categories


Copyright © www.kisedona.com 2016-2025